Jou Jye Computer JJ-1225SUSRI Przewodnik Instalacji

Quick Installation Guide JJ-1225SUSRI (A) Hardware Installation: 1. Standard packaging contains: 2. Push the ”LOCK” rightward to unlock the upper H

M) Tick “Quick format” and click ”Next” N) Click ”Finish”

O) Disk Manager shows “Formatting” P) When format is finished , it shows “Healthy”

Q) Format the other hard disk by refer to steps k) ~s) R) When format is finished, “My Computer” will shows two Physical hard disks

(B)How to build Raid Mode BIG or SAFE50 B-1 How to build Raid : BIG(Span) Set the DIP Switch as following RAID Config Display RAI D Status 4 2

B-2 How to build Raid : SAFE50 B2-1 Set the DIP switch as following and Refer to Step C) ~ R) to build the Raid SAFE50 mode. This time you can se

B-2a See two hard disks B-2b See two healthy hard disks After Raid SAFE50 is finished, you can see two new hard disks, one is with Raid mi

Appendix If you are using ESATA, you will have to connect both mini USB and USBto 5v cables. Trouble shooting A> Can only see “8GB Unallocated” Po

c-1 This is because the Safe(Mirror) mode is under rebuilding. It usually occurred on your first time setting the Safe(Mirror) mode or you change the

3. Open the front door as the direction shown on the picture 4. Put the 1st HDD and 2nd HDD inside the cage slowly(See following picture)

5．Push back the two HDD doors back until the HDD doors close to the cage(see following picture) 6. Push the LOCK leftward to lock the two HDD doors.

7. Connect the 15pin power cable and SATA data cable to the host connections (B) How to Configure your Raid Raid Setting Table RAID Config Displa

ٛ C) Click mouse right button on “My computer” and choose “manage” by clicking mouse left button D) Choose “Disk Management” by clicking mouse le

E) the “Disk Manage shows the hard disks are “Not Install” & “Unallocated” F) Click mouse right button over the red forbid sign and choose “Init

G) Press ”OK” H) Refer steps g) & h) to Initialize Disk 2

j. Hard disks will become “Online” I) Click mouse right button and choose “New Partition”

J) Choose ”Next” K) Choose ”Next” again. ( Suggestion: Tick “Extended partition” is recommended if data in use only) L) Set up partition size an